Cutting of pendants in precious material
Jewel pendants with a name are personalized jewelry that are highly valued for their uniqueness and personal meaning.
Jewel pendants with name
Gold name pendants are often chosen as sentimental gifts for special occasions and add a touch of elegance with the use of gold. These pieces of jewelry are personal, suitable for both everyday wear and special events, and can become family heirlooms passed down from generation to generation.
How do you make name pendants?
To create these extraordinary personalized jewels, the name, initials or graphics are normally cut directly from a sheet of precious material. Many goldsmiths still cut pendants as they once did, with a hacksaw, spending a lot of time both for the cutting and for the subsequent finishing because by cutting by hand there are many imperfections of workmanship to remove. The handmade workmanship is as fascinating as it is anachronistic and difficult to sustain from an economic point of view since a digital cutting machine can perform this type of workmanship completely automatically and with a precision impossible for humans.
The technologies that we can provide you for this application are 2, CNC milling technology and Laser technology.
Our CNC milling machines can use extremely small tools to efficiently cut sheets with the thicknesses commonly used for jewelry, the same machines can also cut beyond 3 mm to make silver pendants or brass costume jewelry. The chips of the milled material will remain inside the special cutting table thus allowing easy recovery of the precious material.
Recommended machines: Magic E3, Magic E7
Laser machines are perfect for cutting pendants in precious materials, cutting times depend on the installed power and the type of material to be cut and the results obtained with this technology are always very defined as it allows you to create even the tightest angles. Once the laser cutting parameters have been set, cutting from a sheet is really simple as there is no need to block the sheet or have to pay particular attention to the geometries to be cut. On the other hand, the laser emits toxic fumes and disperses part of the precious material in the fumes. The problem of smoke is solved by connecting the laser to a fume extractor and abatement device, a device that allows you to work in perfect safety and that allows you to recover the precious material that "went up in fume" during cutting.
Recommended machines: Magic L3
With PCube, you will be sure of high quality technical support.
PCube will guide you in choosing the system that best suits your needs, planning the installation and configuring a personalized training course to make the machine operational in the shortest possible time. This way you can immediately take advantage of the new system.